• QUESTIONS? GIVE US A CALL! 1 (630) 655-3900

Navigate to the Occupational Training & Supply Inc. homepage

NEXT DAY DELIVERY
Only in Willowbrook surrounding areas

Surfactant/Wetting Agent 5 Gal Pail
Surfactant/Wetting Agent 5 Gal Pail - Image 1 of 0
Surfactant/Wetting Agent 5 Gal Pail - Image 2 of 0
Surfactant/Wetting Agent 5 Gal Pail - Image 1 of 0
Surfactant/Wetting Agent 5 Gal Pail - Image 2 of 0
Surfactant/Wetting Agent 5 Gal Pail - Image 1 of 0
Surfactant/Wetting Agent 5 Gal Pail - Image 2 of 0

Surfactant / Wetting Agent 5 Gal Pail

0 Reviews
$0.00
Product Code: CH6001
View discounts
This ready-to-use wetting agent and surfactant solution provides superior wetting, penetrating and coalescing of Asbestos Containing Material (ACM) to permit handling and removal of these materials under damp, dust-free conditions. Penewet is a non-flammable, water-based liquid that will not corrode aluminum components of spray equipment.
Ready to use formula
Surface Tension: 27 dynes/cm
Satisfies NESHAP requirements
Penetrates and “wets out” asbestos to help create a damp, dust-free environment
How to Use
SURFACE PREPARATION
Carefully clean up with a wet mop or HEPA vacuum. Stir Penewet thoroughly to achieve a uniform consistency. Penewet is pre-mixed, water addition is not necessary.

APPLICATION TOOLS
Apply Penewet with an airless or pump sprayer.

PRODUCT APPLICATION
Apply Penewet initially at full strength. Wait a few minutes after the first application and re-spray to ensure adequate penetration and saturation of ACM. After determining the proper rate of spray that is effective for the removal of the ACM, and documenting acceptable fiber count levels. Air monitoring results will determine the suitability of this procedure.

COVERAGE
Depending on thickness and porosity of the material, coverage should not be less than 500 sq. ft. per gallon.

CLEANUP
Tools and drippings should be cleaned with warm soapy water. Follow equipment manufacturer’s directions to clean spray equipment. Dispose of all waste according to current local, state and federal regulations.

PRECAUTIONS
Store in a dry place at temperatures between 40°F (4.5°C) and 90°F (32°C). Approved respirators must be used to prevent inhalation of asbestos fibers that may be present in the air. Protective clothing should be worn. Careful consideration should be given to all EPA, OSHA and state regulations in effect at the time of application of Penewet.

Reviews

Average Rating:
( 0 )