How to Use
SURFACE PREPARATION
Carefully clean up with a wet mop or HEPA vacuum. Stir Penewet thoroughly to achieve a uniform consistency. Penewet is pre-mixed, water addition is not necessary.
APPLICATION TOOLS
Apply Penewet with an airless or pump sprayer.
PRODUCT APPLICATION
Apply Penewet initially at full strength. Wait a few minutes after the first application and re-spray to ensure adequate penetration and saturation of ACM. After determining the proper rate of spray that is effective for the removal of the ACM, and documenting acceptable fiber count levels. Air monitoring results will determine the suitability of this procedure.
COVERAGE
Depending on thickness and porosity of the material, coverage should not be less than 500 sq. ft. per gallon.
CLEANUP
Tools and drippings should be cleaned with warm soapy water. Follow equipment manufacturer’s directions to clean spray equipment. Dispose of all waste according to current local, state and federal regulations.
PRECAUTIONS
Store in a dry place at temperatures between 40°F (4.5°C) and 90°F (32°C). Approved respirators must be used to prevent inhalation of asbestos fibers that may be present in the air. Protective clothing should be worn. Careful consideration should be given to all EPA, OSHA and state regulations in effect at the time of application of Penewet.
